| View previous topic :: View next topic |
| Author |
Message |
umbra Power Member

Joined: 14 Jan 2012 Posts: 675
|
Posted: Wed Jul 04, 2012 1:33 pm Post subject: Fresh installation does not show the initial Options dialog |
|
|
This applies to all current versions - tested with 8.01rc2 x32, x64, 7.56a.
If you have a fresh installation of TC (no or empty wincmd.ini) and you add a valid wincmd.key to TC's installation folder, on its first run it won't show you the initial Options dialog. _________________ Windows 7 Pro x64, Windows 8 Pro x64 |
|
| Back to top |
|
 |
ghisler(Author) Site Admin


Joined: 04 Feb 2003 Posts: 24702 Location: Switzerland
|
Posted: Thu Jul 05, 2012 8:11 am Post subject: |
|
|
This is intentional: If you have a key, it's very likely that you have used TC before, so TC doesn't show the configuration dialog at start when there is no ini. _________________ Author of Total Commander
http://www.ghisler.com |
|
| Back to top |
|
 |
umbra Power Member

Joined: 14 Jan 2012 Posts: 675
|
Posted: Sat Jul 07, 2012 10:29 am Post subject: |
|
|
When I start a newly installed TC, the first thing I do is to change a few settings. It doesn't matter if I have a key or not, I have to edit some options anyway. The current behavior creates a bit contra-productive exception. Luckily, I'm not it that kind of situation too often, so I don't care too much if you change it or not. _________________ Windows 7 Pro x64, Windows 8 Pro x64 |
|
| Back to top |
|
 |
|