I have now tested this with your settings as follows:
- Total Commander (x64) 10.52RC1, Everything 1.5.0.1321a (x64),
AHK-Skript - 04.10.2022 - Line 164: Run %TotalCmd% /O /T /S LOADLIST:%DestinationFile% - View mode: <Default>
- Columns view: Full
- Sort order: Unchanged - View mode: Branch View
- Columns view: Full
- Sort order: Unchanged
- Auto-run commands: *|cm_SrcViewMode0 - Auto Switch Mode
- Automatically switch view mode on directory change:
- Rule: +: Must match ... Directory: %COMMANDER_PATH%\EV-Results\
- Set this mode: Branch View
- When I run the AHK script (Auto Switch Mode *ON*) I get the search result of Everything in Total Commander
on the tab "Search result:". Both folders and files are listed. Please also see the next point... - By "Branch View" I understand the following:
cm_DirBranch 2026 Show all files in current dir and all subdirs
cm_DirBranchSel 2046 Show selected files, and all in selected subdirs
For a long time I was confused by your use of the term "Branch view", because I expected the search result in TC
to contain only files and not folders. - View Mode - Parameter: |cm_SrcViewMode0
I am not a big fan of this parameter, because an "Auto Switch Mode" ends by itself.
Furthermore, this parameter can possibly override the next "Auto Switch Mode". - The most important point for me is this:
When the AHK script - 04.10.2022 - Line 164: Run %TotalCmd% /O /T /S LOADLIST:%DestinationFile% is executed with this command,
I get the same search result as executed under point 1., and that too WITHOUT using View mode and Auto Switch Mode!
The Auto Switch Mode does not interfere, but in my opinion it is NOT necessary. - For test purposes, please switch the Auto Switch Mode *OFF* by unchecking this option:
⏹ Automatically switch view mode on directory change: ... Then run the AHK script again. - In my opinion, the View mode with Auto Switch Mode is only necessary if you are using the AHK script dated 21.10.2021
with Line 164: Run %TotalCmd% /O /T /S %DestinationDir% (without LOADLIST:).