[BUG] Panel divider at 100% not resizable when TC maximized

[icfu]

Steps to reproduce:
1. Maximize TC
2. Pick up the panel divider
3. Move panel divider to 100% while holding Shift and drop it

=> You cannot pick up the divider anymore.

Workaround:
After restoring and maximizing TC, the divider is shown again.

@ghisler:
Don't forget to also give us more divider commands:
cm_00percent up to cm_100percent in 5 percent jumps, at least 0, 25 75, and 100 are desperately needed.

Icfu

[petermad]

Workaround:
After restoring and maximizing TC, the divider is shown again.

Or use the internal command cm_50Percent from menu or button...

[Clo]

2icfu
Hello Jeff !

- I can confirm, BUT :
Here, this occurs only when I move the divider to RIGHT !

- If I move the same to LEFT, I have still the active vertical strip that I can catch with the lovely <–||–> cursor !

- Conclusion :"Right" is the bad side in all

 V.G.
Claude
Clo

[icfu]

- I can confirm, BUT :
Here, this occurs only when I move the divider to RIGHT !

Yeah, I have mentioned 100% above for a reason.
But, thanks for pointing it out again.

Icfu

[Clo]

Right, but finally, this way to mark the position isn't very logical…
- IMHO, it might be :

-50   <—   0   —>   +50

- Currently, to get the full width as 100%, you must move to "0" or else, it's buggy… Odd …

 VG
Claude
Clo

[SQUIRE]

I can't get the divider to misbehave with TC 6.52. Works perfectly, left or right.

[Lesmo16]

Bug comfirmed only for the right side - so same as Clo.

@ghisler:
Don't forget to also give us more divider commands:
cm_00percent up to cm_100percent in 5 percent jumps, at least 0, 25 75, and 100 are desperately needed.

yeah, support

[Sheepdog]

Confirmed.

To restore the divider it suffices to switch to 'cm_verticalPanels' and back.

sheepdog

[Eidt]

While Squire states, that he can't reproduce this bug with 6.52 (did you use TC maximized?) I can reproduce this bug down to Version Windows Commander 4.52. With Windows Commander 4.51 it works fine.

[/edit]

[Sir_SiLvA]

cm_100percent...are desperately needed.

instead of cm_100percent cm_verticalPanels is more usefull otherwise you could use explorer if you dont need 2 panels

[ghisler(Author)]

Thanks, I will put it on my list for TC v7.