I just tried some of the cm_*Quickview* commands (cm_SrcQuickview, cm_LeftQuickview, cm_RightQuickview, cm_SrcQuickInternalOnly and cm_SeparateQuickview) with parameters 1 or 2 - they work fine if I use the command as the only command, but if I use the QuickView commands in combination with other cm_ or em_commands I get the error message "Function not implemented!" and the command toggles QuickView as if no parameter was used.history.txt wrote:15.03.21 Added: Support parameters 0=toggle, 1=set, 2(or -1)=reset also for: cm_SrcQuickview, cm_LeftQuickview, cm_RightQuickview, cm_SrcQuickInternalOnly, cm_LeftQuickInternalOnly, cm_RightQuickInternalOnly, cm_SeparateQuickview, cm_SeparateQuickInternalOnly (32/64)
21.10.20 Added: Support parameters 0=toggle, 1=set, 2(or -1)=reset for: cm_*Comments, cm_*DirBranch, cm_*DirBranchSel, cm_ToggleAutoViewModeSwitch, cm_SyncChangeDir, cm_SwitchLongNames, cm_SwitchHidSys, cm_SwitchHid, cm_SwitchSys, cm_Switch83Names, cm_FtpHiddenFiles, cm_SwitchDirSort, cm_SwitchOverlayIcons, cm_SwitchWatchDirs, cm_SwitchIgnoreList, cm_SwitchX64Redirection, cm_Vis* (32/64)
The same applies to cm_FtpHiddenFiles and all the cm_Vis* (cm_VisButtonbar, cm_VisDriveButtons, cm_VisFlatDriveButtons etc.) commands - they also doesn't work correctly with parameters if combined with other commands. For parameter 1 and 2 I get a "Function not implemented!" message and for parameter 0 I get a "File not found!" message and the command toggles as if no parameter was used.
Examples:
This button works fine:
Code: Select all
TOTALCMD#BAR#DATA
cm_GoToFirstFile,cm_SrcQuickview
WCMICONS.DLL,22
Test
-1
Wheras this button:
Code: Select all
TOTALCMD#BAR#DATA
cm_GoToFirstFile,cm_SrcQuickview 1
WCMICONS.DLL,22
Test
-1
This button
Code: Select all
TOTALCMD#BAR#DATA
cm_SrcQuickview 1
WCMICONS.DLL,22
Test
-1
It doesn't matter whether the affected commands with parameter is used first or last when combined with other commands.