cm_ShowOnlySelected reset after focus change: feature or bug

[now]

After doing a cm_ShowOnlySelected and then leaving and going back to total commander resets the "filter", showing the whole directory contents. This is perhaps a result of Total Commander re-reading the panels when it gains focus, but I was hoping that it would retain its "filtering" between focus changes.

[icfu]

Indeed the panels are reread by default.

Either exclude all needed drives by adjusting the "NoReread" key in wincmd.ini or issue cm_RestoreSelection after the reread.

Icfu

[Lefteous]

Either exclude all needed drives from refreshing by adjusting the "NoReread" key in wincmd.ini

which is also available on the new refresh page in the configuration dialog.

[icfu]

We are geeks, aren't we?

Icfu

[SanskritFritz]

2now
In my case it is only refreshed if a file has been changed in the folder, otherwise the filtering remains even after a focus change.