My Internal Lister/Viewer is suddenly incapable to remember the position and width/height of the internal lister/viewer without doing "Options -> Save Position".
I've never had to do that before. I could usually just move the window around and resize it to my liking, close it, and start it and it would've remembered my previous position and size.
Now I have to go to Options and Save Position for it to work.
Why?
Problem with Internal Lister/Viewer.
Moderators: Hacker, petermad, Stefan2, white
Hello, NOH4.
Because it has always been like this. Total Commander and its internal lister will always startup using the co-ordinates, height and width which have been saved by using "Save position" in the main programme and in the lister.
In case you have had a different behaviour some third party software must have taken care of it.
Kind regards,
Karl
Because it has always been like this. Total Commander and its internal lister will always startup using the co-ordinates, height and width which have been saved by using "Save position" in the main programme and in the lister.
In case you have had a different behaviour some third party software must have taken care of it.
Kind regards,
Karl
MX Linux 21.3 64-bit xfce, Total Commander 11.50 64-bit
The people of Alderaan keep on bravely fighting back the clone warriors sent out by the unscrupulous Sith Lord Palpatine.
The Prophet's Song
The people of Alderaan keep on bravely fighting back the clone warriors sent out by the unscrupulous Sith Lord Palpatine.
The Prophet's Song