I try to use the installation command line parameter "/I1" to select the custom folder where put the config files as described in the Installer command line parameters guide
My complete installation cli command is:
Code: Select all
.\tcmd1103x64.exe /A0 /H0 /L8 /M0 /I1"Z:\Zip\Prg\TotalCMD" "c:\Program Files\TotalCMD"
I try to debug keep only the /I switch in a non Automatic Installation to view the behavior of the installer by this command:
Code: Select all
.\tcmd1103x64.exe /I1"C:\Zip\Prg\TotalCMD" "c:\Program Files\TotalCMD"
I am sure that I have not interpreted the instructions on the installation options correctly and I would be grateful if someone could direct me to the correct path because I have not found any examples online other than the one reported on the wiki
Thank You in advance