UseIniInProgramDir=

[captjlddavis]

Registered user - 6.53
Excuse me if this subject has been beat to death.

TC help shows definitions for:

UseIniInProgramDir=
0 This variable will only be read if the wincmd.ini is located in the same dir as the program.
It is the sum of the following values:
1: Use wincmd.ini in program dir if no other location is set via registry or parameters
2: Use wcx_ftp.ini in program dir if no other location is set via registry or parameters
4: Override registry settings (but not command line parameters)

A search of forum produces several references to settings of:

UseIniInProgramDir=3
UseIniInProgramDir=7

I believe that I understand these settings but would like some clarification.

Where can I find information on these settings (3 & 7)?

regards:captjlddavis

[Lefteous]

2captjlddavis
Hi,

Where can I find information on these settings (3 & 7)?

3 is the sum of the settings 1+2. That means 1 and 2 are set. The effect is that both INI files are read from program dir.
7 is the sum of 1+2+4. The effect is that both INI files are read from program dir and eventually existing registry entries are overrruled.

[captjlddavis]

Lefteous,

thank you very much, that clears it for me very well

regards"captjlddavis