How to start with two panels

[mitch]

I use TC with two panels and then exit it. When I start it again, there is only one panel. Is there a way to always have it display two panels when starting? Or to display the number of panels from the last time it was used?

Mitch

[krypton]

I use TC with two panels and then exit it. When I start it again, there is only one panel. Is there a way to always have it display two panels when starting? Or to display the number of panels from the last time it was used?

Mitch

For only one panel you mean a situation like that below?
Image: http://oi48.tinypic.com/2eajlua.jpg

However, try to proceed in this way:
1-Set two panels by typing this command, or copy & paste it, in the command-line: cm_50Percent
Or set it manually, like you want.
2-Configuration ---> Save Position
Image: http://oi45.tinypic.com/w1zc7o.jpg
3-Close and reopen program

Let me know the result .

[mitch]

Thanks a lot. Save Position was what I needed.