Verify after copy is slow / not configurable
Posted: 2023-05-28, 12:50 UTC
Hello!
I'm using the "verify after copy" option. I found some threads about it here on the non-English forum and also a few on the English one but none with much traction.
Since Total Commander already supports a bunch of different checksum algorithms, would it be possible to make this "verify after copy" checksum algorithm configurable? I have a machine with 10GBit networking and a 4-disk Raid0 for data processing which easily reaches 1GB/s read/networking speeds. However when verification is ongoing, the speed is a measly ~200-240MB/s. If I use for example Blake3, I can easily reach that 1GB/s, so it would be enough if I could configure this verify-after-copy function to just use Blake3.
Please take this as a suggestion since it could potentially be easy to implement, given the fact such algorithm already exists in TC!
Thank you very much!
I'm using the "verify after copy" option. I found some threads about it here on the non-English forum and also a few on the English one but none with much traction.
Since Total Commander already supports a bunch of different checksum algorithms, would it be possible to make this "verify after copy" checksum algorithm configurable? I have a machine with 10GBit networking and a 4-disk Raid0 for data processing which easily reaches 1GB/s read/networking speeds. However when verification is ongoing, the speed is a measly ~200-240MB/s. If I use for example Blake3, I can easily reach that 1GB/s, so it would be enough if I could configure this verify-after-copy function to just use Blake3.
Please take this as a suggestion since it could potentially be easy to implement, given the fact such algorithm already exists in TC!
Thank you very much!