Start TC32 with Vertical panels

[lebans]

Hello,

Is it possible to start TC32 in vertical arrangement by using a commando parameter. Normally I start TC32 in horizontal arrangement. I do it now by using two exact the same ini files with the exception of the line:

PanelsVertical=0 (In wincmd2.ini I use PanelsVertical=1)

But while I'm using these both modes the files get differenced. For normal use I find horizontal beter, but with mp3 files I like it in vertical mode.
I would like to use one ini file so all the other changes are equal in both modes.

I hope I've been clear

[Coco]

Hi lebans,

Not it's not possible.
ps: You can find all command line parameters in the help file.

[Black Dog]

[face=courier]On 05-12-2003 01:34:48 +0000 lebans wrote:

l> Is it possible to start TC32 in vertical arrangement by
l> using a commando parameter.

Why don't you just use KBD shortcut to switch this modes? You can use my interface pack - if you set it up with [Shortcuts] section it would be ^G.[/face]

[lebans]

I do use F12 to change between Vert and Hor mode. Thanks. I would like to start a new copy of TC32 in vertical mode by using a toolbar button without the need of a second ini file. I use now th parameter:

/L=%p /R=%t /N /I=.\wincmd2.ini