Hello,
Is it possible to start TC32 in vertical arrangement by using a commando parameter. Normally I start TC32 in horizontal arrangement. I do it now by using two exact the same ini files with the exception of the line:
PanelsVertical=0 (In wincmd2.ini I use PanelsVertical=1)
But while I'm using these both modes the files get differenced. For normal use I find horizontal beter, but with mp3 files I like it in vertical mode.
I would like to use one ini file so all the other changes are equal in both modes.
I hope I've been clear
Start TC32 with Vertical panels
Moderators: white, Hacker, petermad, Stefan2
Start TC32 with Vertical panels
Greetings,
Rob
Rob
[face=courier]On 05-12-2003 01:34:48 +0000 lebans wrote:
l> Is it possible to start TC32 in vertical arrangement by
l> using a commando parameter.
Why don't you just use KBD shortcut to switch this modes? You can use my interface pack - if you set it up with [Shortcuts] section it would be ^G.[/face]
l> Is it possible to start TC32 in vertical arrangement by
l> using a commando parameter.
Why don't you just use KBD shortcut to switch this modes? You can use my interface pack - if you set it up with [Shortcuts] section it would be ^G.[/face]
[face=courier]The Protoss do NOT run from their enemies.
It is here, that we shall make our stand.[/face]
It is here, that we shall make our stand.[/face]